Brake pedal
Brake pedal
Shift pedal
Shift pedal
The operation of the brake and shift pedals should be checked before each ride, and the pedal pivots should be lubricated if necessary.
| Recommended lubricant: Lithium-soap-based grease |
Checking and lubricating the throttle grip and cable
Checking and lubricating the brake and clutch leversChain drive
Removing the drive chain
1. Stand the vehicle on a level surface.
WARNINGSecurely support the vehicle so that there
is
no danger of it falling over.
NOTE:
Place the vehicle on a suitable stand so that the
rear wheel is elevated. ...
Sidestand
The sidestand is located on the left side
of the frame. Raise the sidestand or
lower it with your foot while holding the
vehicle upright.
TIP
The built-in sidestand switch is part of
the ignition circuit cut-off system, which
cuts the ignition in certain situations.
WARNING
The vehicl ...
Removing the front fork legs
The following procedure applies to both of the
front fork legs.
1. Stand the vehicle on a level surface.
WARNINGSecurely support the vehicle so that there
is
no danger of it falling over.
2. Loosen:
Handlebar pinch bolt "1"
Handlebar bolt "2"
Upper bracket ...