Checking the valves and valve guides
The following procedure applies to all of the
valves and valve guides.
1. Measure:
Valve-stem-to-valve-guide clearance
Out of specification Replace the
valve
guide.
Valve-stem-to-valve-guide clearance =
Valve guide inside diameter "a" -
Valve stem diameter "b"
2. Replace:
...
Bearings and oil seals
Install bearings "1" and oil seals "2" so that the
manufacturer's marks or numbers are visible.
When installing oil seals "1", lubricate the oil seal
lips with a light coat of lithium-soap-based
grease. Oil bearings liberally when installing, if
appropriate.
CAUTION:Do not spin th ...
Supporting the motorcycle
Since this model is not equipped with a
centerstand, follow these precautions
when removing the front and rear
wheel or performing other maintenance
requiring the motorcycle to stand upright.
Check that the motorcycle is in a
stable and level position before starting
any maintenance. A ...