Yamaha YZF-R125 Service Manual: Generator and starter clutch

Yamaha YZF-R125 Service Manual / Engine / Generator and starter clutch

Generator and starter clutch


Generator and starter clutch


Installing the piston and cylinder
1. Install: Top ring "1" 2nd ring "2" Oil ring expander "3" Lower oil ring rail "4" Upper oil ring rail "5" NOTE: Be sure to install the piston rings so that the manufacturer marks or ...

Removing the generator
1. Remove: Generator rotor nut "1" Washer NOTE: While holding the generator rotor "2" with the sheave holder "3", loosen the generator rotor nut. Do not allow the sheave holder to t ...

Other materials:

Checking the rear brake hose
1. Check: Brake hoses "1" Cracks/damage/wear  Replace. 2. Check: Brake hose holder "2" Loose connection Tighten the holder bolt. Loose or open holder Fasten properly. 3. Hold the vehicle upright and apply the rear brake several times. 4. Check: Brake ho ...

Changing the engine oil
1. Remove: Right bottom cowling Right upper side cowling Right lower side cowling Refer to "GENERAL CHASSIS" on page 4-1. 2. Start the engine, warm it up for several minutes, and then turn it off. 3. Place a container under the engine oil drain bolt. 4. Install: Engine oil d ...

Supporting the motorcycle
Since this model is not equipped with a centerstand, follow these precautions when removing the front and rear wheel or performing other maintenance requiring the motorcycle to stand upright. Check that the motorcycle is in a stable and level position before starting any maintenance. A ...

2026 Copyright www.yam-r125.net |